![]() The transition between aspects is done by slow turning off and then progressive lighting of the lights to get a nice effect as close to reality. User's manual, schematics and PCB of RS-TCO-DCCĭCC accessory decoder that allows control up to four semaphores of 2 lights showing two aspects (red/green) or four aspects (shunting It includes visualization of lack of DCC signal. By means of the button it's also possible to show in the LED their programmed number of accessory output. The programming of the number of the module is made in a simple way pressing the button and then changing the state of accessory output to be monitored. Several LED can display the same accessory output and you can have multiple TCO joined with just 3 wires. You can program each individual LED to show a accessory output illuminated fixed or flashing. Takes data directly from the DCC signal installed as extension of RS-TCO. To build your own Optical Control Panel (TCO) with LED. User's manual, schematics and PCB of RS-TCO It includes visualization of lack of bus RS. By means of the button it's also possible to show in the LED their programmed number of feedback input. The programming of the number of the module is made in a simple way pressing the button and then changing the state of the feedback input to be monitored. Several LED can display the same occupancy input and you can have multiple TCO joined with just 3 wires. You can program each individual LED to show a occupancy input illuminated fixed or flashing. Takes data directly from the bus RS installed between the command station (or RS2PC) and RS modules. You can connect up to 128 RS modules (up to 1024 feedback inputs) With its Xpressnet connection can send information of command stations with these bus (Lokmaus, Multimaus, Lenz Compact.) to the PC to control locomotives and accessories in addition to the feedback information from RS modules for a complete control of the computer model. GenLI-RS interface sends the information of RS modules to the PC with a compatible Lenz LI100 protocol. User's manual, schematics and PCB of RS2PC-USBįor the control by computer and to directly connect RS feedback modules to the PC. User's manual, schematics and PCB of RS2PC This circuit has four occupancy detectors that works by detection of current for the inputs of the feedback modules RS8 or S88 (and with a little adaptation for Roco 10787) with the advantage that the voltage drop by section is only of a single diode and its optocoupledĪdapting PpP-DC4 to use with Roco 10787 feedback modulesįor the control by computer and to directly connect RS feedback modules to the PC if our command station doesn't have connection for feedback modules (Lokmaus, Lenz Compact.) or to have more feedbak inputs. By means of the button it's also possible to show with the LED the programmed number of the module. The programming of the number of the module is made in a simple way pressing the button and then from the command station selecting a number of accessory and driving it. Connect to the inputs only optocoupled detectors or dry contact. This is the feedback module for RS bus with 8 inputs. It includes visualization of lack of bus RS and lack of DCC signal. It includes a detector of voltage of the DCC signal, by means of which if by any cause there is no voltage in the track (short circuit, etc.) the module 'frezzes' the inputs until the retun of the DCC signal avoiding 'track free' feedback in case of power failures. ![]() This is the feedback module for RS bus with 8 inputs with occupancy detectors with the advantage that the voltage drop by section is only of a single diode and its optocoupled. PpP-RS8-DC Feedback module for RS bus with occupancy detectors
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |